How To Operate The Machine - Clarke US 1500 Manual Del Operador

ENGLISH
EN

HOW TO OPERATE THE MACHINE

WARNING: Machines can ignite flammable
materials and vapors. Do not use
with or near flammables, such
as: gasoline, grain dust, solvents
and thinners.
CAUTION: Allowing the machine to run
without moving forward or back-
ward can cause serious damage
to the floor surface. Make sure
the machine is always moving
when the pad is rotating.
NOTE: You must have training in the operation of
this machine before you use it.
How To Start/Stop The Machine
WARNING: Never start a burnisher when
the handle is in the vertical
position.
The switch to start and stop the machine is activated
by the interlock (1) and the levers (2) under the handle
grips. See Figure 3.
To start the machine, follow this procedure:
1. Depress the handle release lever with your foot and
lower the handle.
NOTE: Make sure you hold the handle with both
hands.
2. Continue to move the handle to the rear until the
handle is in the operating position. The handle
moves freely up and down when it is in the operating
position.
3. Push the interlock switch (1), and apply pressure
to one of the levers (2). See Figure 3.
4. Push the machine forward on the floor. Move the
machine slow on dirty surfaces. Move the machine
faster on cleaner surfaces.
How To Change the Dust Collection Bag
The dust collection bag (see figure 4) should be
replaced after every 10 hours of use. Tip the ma-
chine back onto it's handle. Squeeze in on the
sides of the bag cover and remove it from the
machine. Remove the dust bag and discard. Push
in on the sides of the new bag to pop-it-open and
install it by pushing it down onto the tubes protruding
from the base. Re-install the cover and tip the
machine back upright.
-8-
↑
2
1
Figure 3
Bag
Figure 4
Clarke ® Operator's Manual (EN) - Ultra Speed Burnisher
↑
2
Cover