Installation; Prepare The Cabinet; Prepare The Hood - Bosch HUI34253UC Instrucciones De Instalación

INSTALLATION

WARNING
Remove all tape and packaging before using the appliance.
Discard the packaging after unpacking the appliance. Never
allow children to play with packaging material.

Prepare the cabinet

NOTES: A. The internal height of cabinet has to be
minimum 15", unless the exhaust ductwork is
confi gured horizontally; in this case, the minimum
internal height of the cabinet should be 23'' in
order to allow enough room for the 90° elbow.
B. The hood should be mounted centered over the
cooktop burners.
The cabinet must be heat-resistant up to 194°F (90°C).
The stability of the cabinet must also be ensured after the
cut-out work.
1. Cut a centered hole in the bottom of the cabinet, using
the dimensions shown.
2. Make the cut-outs for the exhaust air duct and the house
wiring cable on top of the cabinet.
NOTE: If the hood will be installed non-ducted, a cut-out
must also be made in the cabinet to allow air to
exhaust through a grill (not included).
After the cut out work is complete, remove the shavings.
6½" or 8½" dia.
(165 mm or 216 mm dia.)
3. Center and secure 2 wood blocks
2" minimum height x 7¼" maximum long, (thickness to
fill but not exceed the space inside the cabinet), on left
and right sides of the hole, fl ush to the edges (fastening
screws for wood blocks are not included).
Dimension A
(distance from air duct hole center and
edge of hole in bottom of cabinet)
6" (152 mm) duct: 3¼" (83 mm)
8" (203 mm) duct: 4⅛" (105 mm)
(not included) having

Prepare the hood

1. Disassemble both sections of the electrical compartment
cover (grey parts in illustration below) from inside the hood
by removing the 3 retaining screws. Set aside the cover
sections along with the screws.
2. Punch out the knock-out hole on top of the unit (A), then
install a 7/8'' diameter UL approved strain relief (B) (not
included).
A
Front
3. Secure the included 6'' diameter duct connector (for
HUI34253UC, HUI30253UC or HUI36253UC model) or
the included 8'' round duct connector (for HUI80553UC
or HUI86553UC model) to the top of the hood using
4 no. 8 x 3/8'' screws (included in parts bag). Seal the joint
with aluminum duct tape.
NOTE: If the hood will be installed non-ducted, remove both
damper fl aps from duct connector.
Screws
Screw
B
Front
Damper
fl aps
English 11