Operating Instructions; Table Saw Displacement; Starting And Stopping The Table Saw; Adjusting The Saw Blade Height - VITO PRO-POWER VISCB20 Manual De Instrucciones

On the right side
1. Side with 2 round holes (40 cm between holes)
touches the right side of the table and tighten with 2
hex screws, 2 plate washers, 2 spring washers and 2
nuts;
2. Use the support bars B which are secured to the rear
cross bar with 2 hex screws, 2 plate washers, 2 spring
washers and 2 nuts. They are also secured to the
extension table in the two holes (30 cm between
them).

OPERATING INSTRUCTIONS

The appliance was designed to cut wood and its
derivatives.
While operating the appliance some precautions and
work procedures must be taken into account:
▪ Do not operate the table saw under poor lighting
conditions.
▪ Do not use the table saw while you are tired or under
the influence of medication, drugs or alcohol.
▪ Always keep your focus when working, be aware to
always maintain a safe working posture;
▪ Do not operate the table saw outdoors when there
are unfavorable weather conditions;
▪ The table saw should only be used by trained people;
▪ Always unplug the power cord before performing any
maintenance work.
▪ The guards must be always installed for your safety.
42

Table saw displacement

The table saw can be moved according to your work
needs.
To move the table saw from one place to the other, lift
it by the carry handles and move.

Starting and stopping the table saw

1. Plug an extension cord into the saw plug;
2. Press the push-button (I) on the "ON/OFF" switch
(11) to switch on the appliance;
3. To switch off the power tool, press (0) push-button;

Adjusting the saw blade height

Always adjust the height of the saw blade so that the
top is always 2-3 cm above the workpiece.
To adjust the height, simply turn the knob:
▪ Clockwise, the saw blade rises;
▪ Counter-clockwise, the saw blade lowers;
It features a scale to adjust to the desired height.