Descargar Imprimir esta página

General Assembly Instructions; Unpacking Your Wet/Dry Vacuum & General Assembly - Vacmaster VOM205P Manual Del Usuario

Publicidad

Idiomas disponibles

Idiomas disponibles

GENERAL ASSEMBLY INSTRUCTIONS

Tools Required for Assembly: Philips Head Screwdriver
Helpful Tools: Level
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY
VACUUM. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
1
2
7
8
14
13
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 6 (Fig. 4).
5. Insert the handle into the slots located on the top of the power head. Apply force to lock the
handle into place (Fig. 5).
6. Your vacuum comes ready for dry vacuum cleaning. If the reusable cloth filter is not installed,
refer to page 13 for installation instructions (Fig. 6 & 7).
7. For wet vacuum cleaning, remove the reusable cloth filter, and install the supplied foam wet
filter. See page 13 for the foam wet filter installation instructions (Fig. 8).
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
3
1
2
9
4
5
11
9 10
7
6
12

Publicidad

loading