Publicidad
Operation Instruction of H5000 Series Inverter
This parameter setting is related to the stabilization of current
display, please do not modify in general situation. If the setting
is much lower, current display will fluctuate.
F8.07 0 – 10V Analog output low-end correction factor
Range
F8.08 0 – 10V Analog output high-end correction factor
Range
F8.09 0 – 20mA Analog output low-end correction factor
Range
F8.10 0 – 20mA Analog output high-end correction factor
Range
The above parameters are default settings. Thus shall not be
corrected, otherwise it will cause abnormal running of Inverter.
F8.11 Interval compensation frequency point
Range
F8.12 UP/DOWN frequency memory selection
Range
F8.11 forward/reverse operation compensation frequency point
The running frequency is lower than the set-up value, which
will increase the forward/reverse operation compensation. The
suggestion for the set-up value is above 10.00Hz.
F8.12UP/DOWN frequency memory selection
When choosing "UP/DOWN" to set up the frequency, the parameter is
set as 0, and the frequency remain the same after stopping. The
parameter is set as 1, and the frequency become 0 after stopping.
Manual de Funcionamiento del variador de la serie H5000
0 – 65535
0 – 65535
0 – 65535
0 – 65535
0 –maximum operation
frequency
0: stored 1: not stored
Unit
Unit
Unit
Unit
Unit
Unit
218
default: *
1
default: *
1
default: *
1
default: *
1
default: 0.00
1
default: 0
1
Publicidad
