Assembly And Adjustments - Black and Decker BCHV001 Manual De Instrucciones

ENglIsh
Important Charging Notes
1. The charger and battery pack may become warm to the
touch while charging. This is a normal condition, and
does not indicate a problem. To facilitate the cooling of
the battery pack after use, avoid placing the charger or
battery pack in a warm environment such as in a metal
shed or an uninsulated trailer.
2. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a lamp
or other appliance;
b. Check to see if receptacle is connected to a light
switch which turns power off when you turn out
the lights;
c. If charging problems persist, take the tool, battery
pack and charger to your local service center.
3. You may charge a partially used pack whenever you
desire with no adverse effect on the battery pack.
Charger Cleaning Instructions

WARNING:
charger from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the charger
using a cloth or soft non-metallic brush. Do not use
water or any cleaning solutions.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE

ASSEMBLY AND ADJUSTMENTS


WARNING:
serious personal injury, turn unit off and remove
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Removing Dust Bowl (Fig. C)
1. Remove the dust bowl
release button 2 and pulling the dust bowl down and out.
Installing Dust Bowl (Fig. C)
1. Install the dust bowl
audible click. Ensure the dust bowl is secured in place
before using.
Installing Accessories (Fig. D)
1. The crevice tool 7 allows for vacuuming in narrow and
hard to-reach places.
2. To attach an accessory, press the accessory into dust bowl
3. The crevice tool 7 can be stored on the unit as shown in
Fig D.
28
Shock hazard. Disconnect the
To reduce the risk of
3 by pressing the dust bowl
3 onto the unit and listen for an
OPERATION (FIG. A)

WARNING:
ELECTRIC SHOCK – USE INDOORS ONLY.

WARNING:
personal injury, turn unit OFF before making any
adjustments or removing/installing attachments
or accessories. An accidental start-up can cause injury.

WARNING:
Never use the vac without its filter.
Installing and Removing the Battery Pack
(Fig. E)
NoTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in the
tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 6 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
On/Off Switch (Fig. F)
NoTE: This product is for dry pick-up only.
• To switch the vac on, slide the On/Off switch
• To switch the vac off, slide the On/Off switch
MAINTENANCE

WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Your BLACK+DECKER power tool has been designed to
operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Cleaning

WARNING:
of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always
3 .
wear ANSI Z87.1 approved eye protection when
performing this procedure.

WARNING:
harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic
TO REDUCE THE RISK OF
To reduce the risk of serious
Projectile/Respiratory Hazard:
5 into the tool handle, align the
1
1
To reduce the risk of serious
Blow dirt and dust out
Never use solvents or other
forward.
back.