Publicidad
Idiomas disponibles
Idiomas disponibles
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
TO STOP HEATER
CAUTION ; Never unplug heater while heater is running
Heater must go through cooling cycle. The cooling cycle cools the
combustion chamber. Damage to heater can occur if combustion chamber
is not cooled. Do not restart heater until cooling cycle is complete.
1. Turn "THERMOSTAT CONTROL KNOB" to lowest temperature setting.
This will cause heater flame to go out.
The motor will continue to run during the cooling cycle.
This allows the fan to cool the combustion chamber. When the cooling cycle
(approx.1Min) is finished, the motor will stop.
Do not turn switch to "OFF" or unplug heater until cooling cycle is finished.
2. Turn switch to "OFF" and unplug power cord.
3. To temporarily stop heaters, set thermostat at a temperature lower than air around heater,
Heater will cycle back on if air temperature around heater matches thermostat setting.
TO RESTART HEATER
CAUTION ; Do not restart heater until cooling cycle is finished.
The cooling cycle cools the combustion chamber.
1. Wait until cooling cycle is finished after stopping heater.
2. Repeat steps under to start HEATER.
EXTRA ELECTRIC OUTLET
Figure 5. EXTRA ELECTRIC OUTLET
WARNING ; SHOCK HAZARD!
Always cover electric outlet when not in use.
Do not plug in and use an appliance of more than 120V 5A current in this outlet.
All manuals and user guides at all-guides.com
COVER
ELECTRIC OUTLET
7
Publicidad
Solución de problemas
