Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Remove the two (2) screws securing the burner tube to the
burner base. Refer figure 1 and figure 2 below.
Figure 2 - Gas Valve on the Left Side
A.
Ignitor
B.
Burner Tube
C.
Screws
D.
Pressure Tap Plug
E.
Gas Valve Assembly
2.
Slide burner tube forward far enough to gain access to orifice.
Do not bump ignitor.
NOTE: The ignitor is fragile.
A.
Burner Tube
B.
Gas Valve Assembly
C.
Ignitor
3. Remove the burner orifice from the gas valve assembly and
replace it with the proper orifice furnished in this kit. Orifice
number is stamped on one edge of the hex head of orifice.
Securely tighten.
Propane gas - Use Orifice No. - 55.
Butane gas - Use Orifice No. - .049.
A.
Orifice
B.
Gas Valve Assembly
4. Slide the burner tube back in place and, using the screws
removed in Section 3, step 1 (see figure 1 and figure 2 above),
reattach burner tube to the burner assembly. Securely tighten
the two (2) mounting screws.
5. Before proceeding, you must first determine which gas valve
style is on the dryer. Refer below figures for style "A" and
style "B".
Figure - Style "A" Gas Valve
A.
Vent Cap
B.
Two Separate Coils
11
Publicidad
