Publicidad
selector plate in direction of over or under size
mark on plate. Tighten selector plate screws.
11. To install die head, slip die head onto carriage die
head pin.
Threads
If there is a dangerous situation, release foot from
pedal. This stops the machine.
To restart the machine, press the release button on
the side of the safety pedal.
To guarantee precisely ground threads, follow the
instructions below:
Use only raw material that is in perfect condition
for threads.
If you use deformed and / or pipes cut off at
an angle, it is not possible to cut threads that
conform to the relevant standards!
Use the thread head and the corresponding
thread jaws that matches the thread size! Secure
the thread head correctly on the tool carriage.
Do not place the die head directly and
unprotected on the floor and handle it with care!
Ensure that the thread oil runs on the dies!
Phone 800-545-7698 • FAX 815-633-0879 • www.rothenberger-usa.com
ROTHENBERGER USA – CLASSIC 22A
Installing Dies in Automatic Opening
Die Head (R.H. & L.H.)
The Automatic Die Head (Fig. 11) requires two sets of
dies to thread pipe ranging from
set of dies is required for each of the following pipe size
ranges:(
⁄
" and
⁄
") and (1" through 2"). Bolt threading
1
3
2
4
requires a separate set of dies for each bolt size.
Figure 11
Automatic Die Head
1. Make sure trigger assembly is released.
2. Disengage selector pin and swing it up, out of the
way.
3. Lay head down with numbers up.
4. Rotate selector size bar to OPEN position.
5. Remove die segments Nos. 1, 3 and 4. Move die
segment No. 2 until die pin can freely travel in
outer scroll slot.
6. Rotate selector size bar counterclockwise until
No. 2 die segment pin is free and can be removed
from die head.
7. Die numbers 1 through 4 must agree with those
on die head.
8. Slide No. 2 die segment in die head slot as far as
possible. Rotate selector size bar clockwise until it
stops. Push segment 2 into the die head as far as
possible.
11
⁄
" through 2". One
1
2
ENGLISH
Publicidad
