Publicidad
14
Nipplemax,
Threading Nipples
1. Ream the inside of the pipe and thread one end
with threading machine.
2. Cut the pipe to required length.
3. Chuck the Nipplemax in the front chuck, being
careful to mount it centered.
4. Put the already-threaded end of the pipe on the
Nipplemax.
5. IMPORTANT: Press the die head with dies
against the pipe firmly, BEFORE switching on the
machine.
6. After the thread is completed, the nipple can be
easily removed by hand.
Notes:
A. The pipe end which will be put on the
Nipplemax should be reamed to remove all I.D.
burrs.
B. The nipple should be put completely on the
Nipplemax.
C. Jaws slots and grooves should be kept clean.
D. Do not start machine until dies contact the
nipple, to avoid slipping.
How to Replace Jaws in Nipplemax:
(see close-up view)
1. Pull down sleeve.
2. Remove retainer (b) from body with a screwdriver.
Don't distort wire.
3. Pull up sleeve to remove it from body.
4. Remove jaws from inside of sleeve and remove
ring to clean slots.
5. Clean jaws, grooves and slots.
6. Put in new jaws.
7. Put sleeve with jaws on body. If it was necessary to
remove ring (a) to clean slots, put ring (a) on body.
ENGLISH
ROTHENBERGER USA – CLASSIC 22A
⁄
" – 2"
1
8
Part No.
00089
Nipple Max Kit,
00190
⁄
" Chuck
1
2
00191
⁄
" Chuck
3
4
00192
1" Chuck
00193
1
⁄
" Chuck
1
4
00194
1
⁄
" Chuck
1
2
00195
2" Chuck
00199
Shank, for Nipple Max Chucks
For the standard thread head:
Lower the thread head and move the opening and
closing lever down towards you.
Turn T.O.R.-switch to "thread" and switch on the
machine with the pedal, turn the rotary handle
clockwise so that the thread jaws press on the
workpiece.
Release the rotary handle when two to three
threads have been cut.
With the machine running, slowly move the
opening and closing lever up when the required
number of threads has been cut, so as to end the
cutting process by slowly opening the thread jaws.
If the thread jaws are opened carelessly, steps can
be created in the last section of the thread, with the
result that the thread is faulty!
While threading, open die head before carriage
reaches full length of travel. If carriage strikes base,
excessive strain is put on the machine and damage
may result!
For the automatic thread head:
Two different thread length gauges are used on the
trigger for NPT and BSPT.
Do not lean over automatic opening die head as
opening lever could strike face when automatically
opened!
Install the die head on carriage pin and adjust the
proper size. Pull operating lever forward to cock
the spring loaded plunger.
Turn T.O.R.-switch to "thread" and switch on the
machine with the pedal, turn the rotary handle
counter-clockwise so that the thread jaws press
onto the workpiece.
www.rothenberger-usa.com • Phone 800-545-7698 • FAX 815-633-0879
Description
⁄
"-2", with Extension Bar
1
2
Publicidad
