Important Safety Instructions - Sears Kenmore 385.19000 Manual De Instrucciones

Tabla de contenido

Publicidad

IMPORTANT SAFETY
INSTRUCTIONS
Your sewing machine is designed and constructed
only for HOUSEHOLD
use.
Read all instructions
before using this sewing machine.
DANGER _ reduce
the r isk ofe'ectric
shock:
1. A sewing machine should never be left unattended
when plugged in. Always unplug this sewing
machine frmn the electric outlet
immediately
after using and before cleaning.
2. Always unplug before replacing sewing machine bulb. Replace bulb with same type rated 13.2 V d.c.,
3 Watts.
3. Do not reach for a sewing machine that has fallen into water. Unplug immediately.
4. Do not place or store sewing machine where it can fall or be pulled into a tub or sink. Do not place
or drop into water or other liquid.
WAR NING
- To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Do not allow to be used as a toy. Close attention
is necessary when this sewing machine is used by or
near children.
2. Use this sewing machine only for its intended
use as described in this manual.
Use only attachments
recommended
by the manufacturer
as contained
in this manual.
3. Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it
has been dropped or damaged,
or dropped
into water.
Return the sewing machine to the nearest authorized dealer or service center for examination,
repair,
electrical or mechanical
adjustment.
4. Never operate the sewing machine with any air opening blocked. Keep ventilation openings
of the sewing
machine and foot controller
free from accumulation
of lint, dust, and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
8. To disconnect,
turn all controls to the off ("0")
position,
then remove plug from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around the sewing machine needle.
11. Always use the proper needle plate. The wrong plate can cause the needle to break.
12. Do not use bent needles.
13. Do not pull or push fabric while stitching. It may deflect the needle causing it to break.
14. Switch the sewing machine off (" "0") when making any adjustment
in the needle area, such as
threading
needle, changing
needle, threading
bobbin or changing presser foot, and the like.
15. Always unplug the sewing machine from the electrical oudet when removing covers, lubricating,
or
when making any other adjustments
mentioned
in the instruction
manual.
SAVE THESE INSTRUCTIONS
When using your sewing machine
for the first few times, place a waste fabric under the presser foot
I
I
and run the machine
without
thread for a few minutes. Wipe away any oil which may have appeared.
I

Publicidad

Tabla de contenido
loading

Tabla de contenido