GET ECULMB Guia De Instalacion página 11

ZERO TPS CALIBRATION – with GET MAYA
To proceed with the ZERO TPS calibration, follow the instruction
in GET Maya manual, which is supplied with the software. GET
Maya is not included in GET ECULMB kit.
If the engine does not start after the TPS calibration or if the
engine is irregular:
1. Make sure that the engine is turned off.
2. Turn off the dashboard by turning the key of the main switch
into OFF position. Wait 10 seconds to let the idle control valve
to calibrate.
3. Turn the key of the main switch into ON position, verify that
the engine stop switch is in "run" position and check that the
idle speed is regular by switching the vehicle on.
4. If the engine is irregular, repeat the ZERO TPS calibration
with GET WiFi-COM (included in the kit) or with GET Maya (sold
separately).
EN
11