Intended Use; Identification Plate; Operating Controls; Start-Up - Wolf Garten Lycos 40/300 T Manual De Instrucciones

EN

Intended use

The trimmer with inserted line spool is intended
solely for the care of lawn edges and smaller grass
and lawn areas in private households.
With the plastic knife inserted, smaller shrubs such
as nettles or brambles can be trimmed.
Any other use is classed as an unintended use. The
user is liable for any damages arising from unin-
tended use.
Incorrect/abnormal use
This trimmer should not be used in public facilities,
parks, sports grounds, roads etc. nor in agriculture
or forestry.
To prevent bodily injury to the user, the trimmer must
not be used to cut thicker branches or for shredding
for the purpose of composting.

Identification plate

Position
The identification plate is located on the trimmer
casing.
Note
The label has the status of a certificate. It
must never be altered or obliterated.
Layout
MTD Products AG
Industriestraße 23
D-66129 Saarbrücken
Lawn Trimmer
LYCOS 40/XXX X
41XXXXXX650
XXXXXXXXXXX
1 Guaranteed sound level
2 Protection class / IP code
3 Manufacturer CE mark
4 Manufacturer
5 Device group
6 Model name
7 Model number
8 Serial number
9 Power
10 Engine speed in rpm
11 Weight
12 Rated voltage, kind of current
13 Disposal instruction
14 Year of manufacture
22
xxx
XXX W
XXXX
XXXX min -
1
XX kg
36 V

Operating controls

Operating controls Q
1 Power pack release
2 Handle
3 Eco button
4 Hook for carrying belt
5 Middle handle
6 Fastening sleeve
7 Locating button edge cutting function
8 Protective cover
9 Line knife
10 Plant protection bow
11 Power pack compartment
12 On/off switch
13 Lock-on switch
14 Carrying belt
15 Spool cap for plastic knife
16 Plastic knife
17 Spool cap
18 Line spool
19 Line box
20 locating button, working angle
Supplementary documentation
Make sure the supplied instruction man-
uals of the charger and the power pack
are available. Please read and under-
stand them before using the device.
Power pack charging
Risk of injuries or material damage
¾ Only charge the power pack using the
charger approved by the manufactur-
er. The designations of the approved
chargers are listed in the enclosed CE
Declaration of Conformity.
Attention!
The power pack is supplied partially charged. Be-
fore first use, fully charge the power pack to ensure
full capacity of the power pack.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.
Operating times
3 Observe the times stipulated in local byelaws.
Check with your local authorities to determine if
Î
there are any operating time limitations.

Start-up

WARNING!
Intended use