Servicing - Wolf Garten Lycos 40/300 T Manual De Instrucciones

Servicing

Risk of injury on the cutting device that is
used for shortening the line length.
¾ After pulling out new line, always hold
the device in its normal working position
before you switch it on.
Manual line adjustment may be necessary during
first use after changing the line spool.
Press button 1 .
Î
Pull the line out 2 .
Î
Using plastic knives A N
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
line or the plastic knife.
¾ Always remove the power pack prior to
working on the device.
Use the plastic knives Ak , so that it also possible to
trim smaller shrubs such as nettles or brambles.
Remove the spool cap 1 / 2.
Î
Turn the spool body in the line box, until the line
Î
only projects about 2 cm from the line box 3 .
Attach two plastic knives Ak on the spool cap
Î
Aj 4 .
Carefully pull the plastic knives outwards until they
Î
engage 5 .
Bring the spool cap for the plastic knives Ak
Î
into the assembly position so that the arrow is on
the spool cap above the button for manual line
adjustment.
Simultaneously strongly press both of the en-
Î
gaging lugs of the spool cap together 6 and set it
onto the line box until it engages 7 .
Removing the power pack O
Switch off the device and wait until all moving
Î
parts have come to a standstill.
Press the power pack release 1 .
Î
Remove the power pack 2 .
Î
CAUTION!
WARNING!
Servicing
Risk of injuries or material damage due to
moving parts.
¾ Only clean or service the device if the
motor is stationary and also the cutting
tool.
¾ Always remove the power pack prior to
working on the device.
¾ Do not clean the device with water.
¾ Repair and service work as well as the
replacement of safety elements must
be performed by a qualified expert or
workshop.
Cleaning
Switch the trimmer off and wait until the cutting
Î
tool comes to a standstill and remove the power
pack.
Clean the device with a hand brush after every
Î
use.
Clean the ventilation slots and underside of the
Î
device at regular intervals to remove grass resi-
dues.
Attention!
Do not clean the device with water.
Replacing the line spool P
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
lines / plastic knives.
¾ Always remove the power pack prior to
working on the device.
Simultaneously strongly press both of the en-
Î
gaging lugs of the spool cap together 1 and pull
it off 2 .
Remove the line spool 3 .
Î
If necessary, remove any dirt.
Î
Extend the thread out of the new spool fitting
Î
(optional accessories) 4 .
Insert the spool in the line box 5 .
Î
Thread both line ends of the spool through the
Î
eyes of the line box 6 .
Simultaneously strongly press both of the en-
Î
gaging lugs of the spool cap together and push it
on to the line spool until it engages 7 .
WARNING!
WARNING!
EN
25