Publicidad
Idiomas disponibles
Idiomas disponibles
Open the door on the cowling;
Unscrew the fuel tank cap;
Fill with fuel and close the tank and engine access door;
IMPORTANT! Petrol is highly inflammable; Store the
fuel in suitable containers; Always fill with fuel in the
open air and do not smoke; Fill with fuel before
starting the engine; Never remove the fuel cap or
add fuel while the engine is in operation or hot; In
the event of petrol leaks, do not attempt to start the
engine. Remove the machine from the area affected
by the leak, avoiding all sources of ignition until the
petrol vapours have dissipated; Always replace the
caps on the tank and petrol container correctly.
Models 650 ET and 850 ET require additional operations depending
on how the order was placed:
If the batteries were ordered together with the machine, they will
already be mounted and checked by the Manufacturer or dealer and
before use, the side brushes must be mounted as described above;
IMPORTANT – Do not tilt the machine with the
batteries mounted: remove the batteries before tilting
the machine.
If this is not the case, the customer must obtain 1 x 12 V 120
Ah battery or 2 x 6V 240 AH batteries (with relevant 12V 10 A
for bat. 120 and 20A for bat. 240,
perform the following operations.
IMPORTANT – Do not use battery chargers with
different powers to charge the batteries
Open the cowling by unscrewing the screws;
Cowling fixing
screws
Screw
Tank cap
6 Description
Below is a list of the contents of the package delivered to the
customer. If one of the parts listed below is missing, contact the dealer
immediately. To avoid loss during transport, the key is enclosed in the
battery charger) and
bag with the technical documents.
Place the battery on the brackets;
Block the battery in place using the belt provided;
Connect the batteries by tightening the terminals on the
battery poles (the positive and negative terminals are
different, preventing the battery from being connected
incorrectly);
Red positive
terminal
Connect the battery cable to the socket on the machine;
Verify the level of electrolyte inside the cells;
Charge the batteries by disconnecting the battery connector
from the machine and connecting it to the battery charger
connector;
Close the cowling using the screws;
6.1 MOTORISED SWEEPER STH
1 x machine;
1 x side brush;
3 x hex socket screws for fixing the side brush;
2 x ignition key
1 x use and maintenance manual;
6.2 MOTORISED SWEEPER ET
1 x machine;
1 x side brush;
3 x hex socket screws for fixing the side brush;
2 x ignition key
1 x battery connection lead
1 x battery charger connector
1 x use and maintenance manual;
1 x battery (if requested);
1 x battery charger (if requested).
Blue negative
terminal
Socket
Battery cable
Publicidad
