Manuales relacionados para Truper LIMI-20A
Resumen de contenidos para Truper LIMI-20A
- Página 1 Manual Cordless impact wrench 20 V 1/2” Frame Applies for: Code Model 101607 LIMI-20A LIMI-20A Read this manual thoroughly CAUTION before using the tool.
-
Página 2: Tabla De Contenido
Parts Start up Keep this manual for future references. Troubleshooting The illustrations in this manual are for reference only. They might be different from the real tool. Maintenance Environmental protection Notes Authorized service centers Warranty Policy LIMI-20A ENGLISH... -
Página 3: Technical Data
Technical Data LIMI-20A Code 101607 Description Cordless impact wrench Frame 1/2” Voltage 20 V Speed 0 - 2 600 RPM Strokes per minute 0 - 3 250 strokes per minute Rotation Forward – reverse IP Grade IP 20 Maximum torque... -
Página 4: Safety Warnings For Power Tools
Safety Warnings for Power Tools WARNING! Read carefully all safety warnings and instruction listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For Cordless Impact Wrench
Safety Warnings for cordless impact wrenchs Batteries and Charger Before operating the tool DANGER • Use only the included • Take your time to evaluate the work to be done and charger to charge the tool battery. Using any other charger make sure you have observed all the necessary may result in fire or risk of injury. -
Página 6: Parts
Parts Frame Retaining ring light Direction of rotation locking button Handle Battery charger Switch Battery release button Battery Charge connection prongs indicator Battery Belt clip Start Up Battery charge 1. Plug the charger plug into a 127 V~ outlet (The green charging indicator light will turn on). -
Página 7: Installing And Removing The Battery
Start Up Considerations for battery use The battery comes DISCHARGED from the factory. You will need to charge it for approximately 1 hour 30 minutes before you can use it. The normal charging temperature is 32 °F to 113 °F. Outside this range, charging is automatically suspended until the correct temperature is reached. - Página 8 Start Up Belt clip • The belt clip can be attached to either side of the tool using only the screw provided, to accommodate left or right-handed users. • If you will never need the hook, you can remove it from the tool. •...
-
Página 9: Troubleshooting
Troubleshooting Problem Cause Solution Tool loses efficiency. • Low battery. • Charge battery. Trigger cannot be • The direction of rotation knob is in the locked • Move the turn direction knob to the turn or pulled. position. reverse position. Trigger can be pulled •... -
Página 10: Notes
Notes ENGLISH... -
Página 11: Authorized Service Centers
Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. -
Página 12: Warranty Policy
. Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Stamp of the business.