Publicidad
Belt clip
• The belt clip can be attached to either side of the tool using only the screw provided, to accommodate left or right-handed
users.
• If you will never need the hook, you can remove it from the tool.
• To move the belt clip to the other side, remove the screw holding the belt clip in place and reassemble it on the other side.
Be sure to tighten the screw securely.
Power on and operation control
• Press the switch to start the operation. Release the switch
to stop the operation.
• The switch allows you to select the appropriate speed for
each task. The harder you press the switch, the faster the tool
will operate.
Screwing – unscrewing
Consider the following points as the tightening torque may
be affected by each of them:
• Voltage: low voltage from a nearly fully discharged
battery or cell will reduce the setting torque.
• Fitting size: Failure to use the correct fitting size will cause
a reduction in tightening torque.
• Bolt size: Larger bolt diameters generally require more
tightening torque. Tightening torque also varies according
to length, grade and torque coefficient.
• Bolt: Make sure all threads are free of rust and other
debris to allow proper tightening torque.
• Material: The type of material and surface finish of the
material will affect the tightening torque.
• Tightening time: Longer tightening time increases the
tightening torque. Longer than recommended tightening
time may put too much stress on the fasteners or cause
them to roll or become damaged.
8
ENGLISH
Start Up
LED light turns on
while the switch is
pressed and turns off
when the switch is
released
Publicidad
