Teac AG-D9100 Manual Del Usuario página 12

AUDIO OPERATIONS
Manual Tuning
1
POWER ON
Manual Tuning is generally used to tune to stations
broadcasting a signal that is too weak to be received
by Auto Tuning.
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the MODE button to change to TUNING mode.
(The PRESET CH. indicator disappears from the
display.)
4. When the UP or DOWN TUNING button is pressed
momentarily (0.5 second or less), the frequency
changes by a fixed step (see STEPS below).
STEPS
FM: 50-kHz steps
AM: 9-kHz steps
FM MODE
2
3 4
Direct Tuning
Using this method, the required frequency is input
directly, using the numeric keys.
4
3
1. Press the TUNER button.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the DIRECT TUNING button on the remote
control unit, ''ENTER FREQUENCY'' appears on the
display for a few seconds.
''FM MHz'' or ''AM - - - - kHz'' appears on the
- - - .- -
display.
4. Input the frequency of the broadcast you want to
hear with the numeric keys.
If you press the DIRECT TUNING button again or
without pressing any button for 30 seconds, Direct
tuning is released.
FM: 50-kHz steps
AM: 9-kHz steps
Ex.: FM 107.55 MHz
Ex.: AM 1008 kHz
– 12 –
1
2
¶ ¶ ¶ ¶
¶ ¶ ¶ ¶