Connecting Speaker Systems; Connecting The Ac Power - Teac AG-D9100 Manual Del Usuario

AM (MW) Antenna
AM Indoor Loop Antenna
A high-performance AM loop antenna provided with the
receiver is sufficient for good reception in most areas.
Connect the loop antenna's wires to the AM antenna
terminals as shown. Place the antenna on a shelf, for
example, or hang it on a window frame, etc., in the
direction which gives the best reception, as far away as
possible from the entire system, speaker cords and the
power cord, to prevent unwanted noise.
AM Outdoor Antenna
If the AM loop antenna provided does not deliver
sufficient reception (because you are too far from the
transmitter or in a concrete building, etc.), it may be
necessary to use an outdoor AM antenna. Use an
insulated wire more than 15 ft (5 m) long, strip one end,
and connect this to the terminal as shown. The antenna
wire should be strung outdoors or indoors near a
window. For better reception, connect the GND terminal
to a reliable ground.
Note:
Even when using an outdoor AM antenna, do not dis-
connect the AM loop antenna.
AM Loop Antenna
(provided)

Connecting Speaker Systems

Caution:
To avoid damaging the speakers by inputting a
sudden high-level signal, be sure to switch the power
off before connecting the speakers.
Connect the cable from each speaker to the correspond-
ing terminal on the rear of the receiver.
Most speaker cables have different markings, textures
or colors to help you tell the difference between neg-
ative and positive.
Be sure to connect the positive (+) terminal on each
speaker to the positive (+) terminal on the receiver.
Similarly, connect the negative (-) terminal on the
speaker to negative (-) terminal on the receiver.
Notes:
Use speakers with a nominal impedance of 8 ohms
or more.
When using the rear speakers, be sure to connect
them to both channels (L and R). If a speaker is con-
nected to only one channel, no sound will be heard.
(1) Strip back the cable covering by about 1 cm and
(2) Turn the terminal cap counterclockwise to loosen it.
(3) Insert the wire into the terminal fully and turn the
AM Outdoor
Antenna
(4) Make sure it is fastened firm by pulling the cable

Connecting the AC Power

Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging
the power cord.
– 7 –
How to connect
twist the wire strands together.
The speaker terminal caps cannot be fully removed
from the base.
terminal cap clockwise to securely connect it.
lightly.