Publicidad
Idiomas disponibles
Idiomas disponibles
PUMPS MODEL
CK-C 110-120-146-220 P
C 53.2-75 P
To draw the "B" dimension it is necessary to refer to the specific manufacturer's catalogue of the car-
dan shaft used.
4.2 USE WITH MOTOR/ENGINE (PUMP "PP" SERIES)
The manufacturer of the complete machine is responsible of the proper selection and correct size of
the operation system to prevent possibly bodily injury.
When wiring an electrically driven pump follow all electrical and safety EN 60204.1 standards to
prevent accidents.
In particular all moving parts must be properly protected and covered, in compliance with the
machines directive 2006/42/CE or with the norms in force in the country the system is used, to
prevent bodily injury.
If the pump shaft has a double P.T.O., the one that is not used must be protected with a proper
shield.
In case of damage or failure of the shaft protection or of the shaft itself, immediately stop the sys-
tem and contact a skilled technician.
When using, do not lean hands or feet on the shaft protection.
The pump-engine/motor unit must be properly fixed on a sufficiently large and strong base.
All the electric wirings must be carried out by skilled technicians.
In case of direct drive with the engine/motor make sure that:
The motor/engine shaft is perfectly aligned and centred as to the pump shaft.
-
The keyway is of correct length.
-
The coupling is correctly sized.
-
In case of gearbox drive follow the same above recommendations as to the coupling between en-
gine/motor shaft – primary shaft and secondary shaft – pump shaft.
In case of pulleys drives check:
–
There is not any slack between shafts and pulleys.
That pulleys are parallel and aligned.
–
–
That belts are correctly stretched. An excessive belts tension will cause a premature wear of
the bearings.
SAFETY GUARDS PROJECTION "A" ( mm )
SAFETY GUARD PART NR.
31.1482.32.2
31.1468.32.2
43
"A" DIMENSION
97,5
114
Publicidad
