Publicidad
Idiomas disponibles
Idiomas disponibles
• Pendulum falls,
• Extreme temperatures
• Chemical reagents,
• Electrical conductivity
-It is essential for the safety of the user that if the product is re-sold outside the original country of
destination the reseller shall provide instructions for use, for maintenance, for periodic examination and
for repair in the language of the country in which the product is to be used.
LIFETIME
The estimated product lifetime is 11 years from the date of manufacture (1 year storage + 10 years for
use). The following factors can reduce the lifetime of the product : intense use, contact with chemical
substances, specially agressive environment, extreme temperature exposure, UV exposure, abrasion,
cuts, violent impacts, bad use or maintenance.
The required annual examinations will validate the correct functioning of the equipment. It is
compulsory that the equipment is examined by the manufacturer or his authorized representative at least
once a year.
In case that it have been used to arrest a fall, the equipment must be withdrawn from use.
TRANSPORT
The Personal Protective Equipment must be transported in a package that protects it against moisture
or mechanical, chemical and thermal attacks.
INSTRUCTIONS FOR MAINTENANCE
-
CLEANING: The personal protective equipment must be cleaned without causing adverse effect
on the materials used in the manufacture of the equipment. For textile (webbing and ropes) and plastic
parts wipe with cotton cloth or a soft brush. Do not use any abrasive material. For intensive cleaning
wash the harness at a temperature between 30ºC and 60ºC using a neutral detergent. For metallic parts
wipe with a wet cloth. When the equipment becomes wet, either from being in use or when due to
cleaning, it shall be allowed to dry naturally, and shall be kept away from direct heat.
-
STORAGE: Personal protective equipment should be stored loosely packed, in a dry and well -
ventilated place, protected from direct light, UV degradation, dust, sharp edges, extreme temperature
and aggressive substances.
REPAIR
Any repair shall only be carried out by equipment manufacturer or his authorized representative
following manufacturer's procedures.
MARKING The equipment is marked with the next information:
i)Identification of the manufacturer
ii) Reference of the equipment
iii) Lot number or serial number
iv)Year of manufacture
v)Material
vi)European Norm
vii)Notified body number
INSTRUCTIONS FOR PERIODIC EXAMINATIONS
It is necessary to carry out regular periodic examinations. The safety of the users depend upon the
continued efficiency and durability of the equipment.
The personal protective equipment shall be examined at least every 12 months. The periodic
examination can only be carried out by the manufacturer or his authorized representative.
The comments should be included in the check card of the equipment. After the periodic
examination, the next due date for periodic examination will be determined.
During periodic inspection it is necessary to check the legibility of the equipment marking.
Publicidad
