Technical Information; Installation Considerations - Hansgrohe Talis S 100 72020 1 Serie Instrucciones De Montaje

English

Technical Information

Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
72020XX1, 72010XX1
72025001, 72018001
72200XX1
Hole size in mounting
surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The drain is intended for use in a sink with an
overflow. If your sink does not have an overflow,
or if this drain is too small for the hole in your sink,
please refer to the instructions included with the
sink. Some sinks include special drain installation
instructions and/or parts. Others require the use
of a specialty drain. Hansgrohe is not respnsible
for the cost of a specialty drain.
Models #72025001 and #72018001 do
not include either a drain or a pull rod.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
1.0 GPM (3.8 L/min)
2.2 GPM (8.3 L/min)
1⁵⁄₁₆"-1⁷⁄₁₆" (34 - 37 mm)
1⅛" (30 mm)
• Model #72200XX1 only: The discharge
water temperature from a bidet fitting shall be
limited to a maximum temperature of 110ºF
(43ºC) by a water temperature limiting device
conforming to ASSE 1070.
• The hot and cold supply hoses included with this
faucet are for use with ⅜ stops. If your stops are
a different size, install new stops. Adapters are
not available from Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.