Publicidad
Idiomas disponibles
Idiomas disponibles
Preliminary checks
Before switching on the machine, make sure that the pellet hopper is full, the combustion chamber
is clean, the glass door is closed, the power supply plug is connected and the switch on the back
is set to "1."
Information on the display
TURNED OFF
21 : 10
The machine is off.
22°C
P-1
TURNED OFF
TURNED ON
14 : 35
The machine is in the fi rst
21°C
P-2
ignition phase. The glow
TURNED ON
plug and fume extractor are
active.
LOAD PELLET
14 : 35
In this phase of the ignition
21°C
P-2
process the machine starts
LOAD
loading the pellets into
pellet
the brazier. The glow plug,
the fume extractor and the
cochlea engine are active.
FIRE PRESENT
14 : 35
In this phase of the process
22°C
P-1
the fi re is present. The fume
FIRE
extractor and the cochlea
present
engine are active.
WORK
15 : 18
The machine is working, in
22°C
P-3
this case at power 3. The
WORK
detected room temperature
is 22°C. During normal
work, the fumes fan, the
auger motor and the room
fan are active.
BRAZIER CLEANING
15 : 18
The machine is cleaning
22°C
p-2
the basket. The smoke
BRAZIER
extractor runs at maximum
CLEANING
speed and the pellet load is
at minimum.
OK STAND BY
21 : 10
All the requests have been
22°C
P-1
satisfi ed and the machine is
stand by
ready for the "STAND BY"
mode.
HOLD REQUEST
14 : 35
The machine is in a "STAND
21°C
P-2
BY" mode as everything has
HOLD
been satisfi ed and is waiting
REQUEST
for an heating request to
turn on.
WAIT COOLING
14 : 35
The
21°C
P-2
complete the cooling cicle
WAIT
before turning on again.
COOLING
ASH EMPTYING
The boiler burns approx.
1000 kg of pellets. The ash
ASH
container should be emptied.
EMPTYING
(where present).
Having emptied the ash,
press the SET key (key 3) and
MEnu 1 1
ASH RESET
increase power (key 6) up to
menu 11.
Press the SET key (key 3) to
enter the reset ash to zero
no
MEnu 1 1
menu and key 1 of the
ASH RESET
temperature.
Confi rm with the set key (key
3) and press ON OFF (key 4) to
SI
MEnu 1 1
exit the menu.
ASH RESET
LOW PELLET LEVEL
14 : 35
The pellets in the tank are
21°C
P-2
fi nishing and it must be
LOW PELLET
refi lled.
LEVEL
machine
has
to
23
Publicidad
