Installing Signal Attenuator Plates - Dräger Pulsar 7000 Serie Instrucciones De Uso

4.2.5

Installing signal attenuator plates

1. Select required signal attenuator plates.
For open-path gas detectors, use the following signal attenuator plates:
Measuring path
4 m to 8 m
8 m to 16 m
16 m to 200 m
For duct-mount gas detectors, use the following signal attenuator plates:
Measuring path
1 m to 2 m
2 m to 4 m
4 m to 8 m
2. Press the signal attenuator plates into the recesses in front of the lenses.
Signal attenuator plate
on the receiver
-
-
-
Signal attenuator plate
on the receiver
AP 800, inner sections pressed out
-
-
Signal attenuator plate
on the transmitter
AP 800
AP 800, inner sections pressed out
-
Signal attenuator plate
on the transmitter
AP 810
AP 810
AP 810
Operation en
51