Useful Tips; Initial Cleaning; Maintenance; Prolonged Periods Of No Use - Fagor SB-G910 Instrucciones De Instalación, Uso Y Mantenimiento

•
Manual versión:
o
The tilting bratt pan has a wheel.
o
To tilt the pan, turn the wheel clockwise.
o
To lower the pan, turn the wheel anticlockwise.

5.3 Useful tips

Read the useful tips listed below carefully in order to get the most out of your tilting bratt pan.
5.3.1

Initial cleaning

After installing the appliance, the tank must be cleaned before the food is placed in the tank.
Cast iron tub:
• To clean the tank, apply a degreasing soap and rub the tank vigorously.
• Then rinse the tank with plenty of water.
• Finally dry the tank thoroughly and wipe with an oil-impregnated cloth.
Stainless steel bowl:
• Clean the tank with a degreasing soap.
• Then rinse the tank with plenty of water.
• Finally dry the tank thoroughly.
5.3.2

Maintenance

FAGOR INDUSTRIAL recommends a service of all the operating components of the tilting bratt pan
at least once a year to check their condition and the correct operation of the appliance. This service
must be carried out by an OFFICIAL AND/OR AUTHORISED TECHNICAL SERVICE.
The replacement of any functional component that may affect the safety of either the appliance or
the user should be performed by an OFFICIAL AND/OR AUTHORISED TECHNICAL SERVICE,
using the appropriate original spare parts.
Always clean the machine correctly to prolong the service life of the machine.
•
Remove any waste from the machine at the end of each day.
•
Do not use abrasive, corrosive or acid products, chlorine-based detergents, solvents or petrol
derivatives to clean the machine.
•
Do not use pressurised water to clean the machine.
•
It is advisable to regularly clean the inner part of the tub with soapy water that is left to boil for
a few minutes. and then rinse it with plenty of water. Then rinse it with plenty of water and dry.
•
If the power cable is damaged, it must be replaced by the manufacturer, after-sales service
or authorised technical personnel in order to prevent risks.
5.3.3

Prolonged periods of no use

If the machine is kept out of service for a long period of time (holidays, temporary closure...), please
observe the following:
•
Close the gas supply.
•
Clean the machine and the adjacent areas thoroughly.
•
Spray a thin layer of edible oil over the stainless-steel surfaces.
•
Switch off the mains power supply.

6. FAULTS, ALARMS AND BREAKDOWNS

The steps to be followed in the event of a fault or operating error are described below. The possible causes
and possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve the
problem, please contact the technical service.
Do not handle electrical components, as there is a risk of death as the components are
live.
37