Descargar Imprimir esta página

Steinberg Systems SBS-MD-20 Manual De Instrucciones página 30

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 99
3. Adjust the sensitivity. Press the SENS button, then press the "+" or "-" button
to increase or decrease the sensitivity. The sensitivity level will be displayed on
the LCD. To find objects deep in the ground, the sensitivity must be higher. If
the sensitivity is set to the highest limit, it is possible that the detector will emit
false signals.
4. Place the detector on a wooden or plastic table, and then the user should
remove any watches, rings, or metal jewelry the user is wearing.
5. Position the probe so that the flat part of the probe is facing the ceiling.
CAUTION!
buildings have metals embedded in the floor that can interfere with or completely
mask the signal.
6. Slowly move a sample of the material you want the detector to find (e.g. gold
ring, coin) a few centimeters above the probe surface. When the detector
detects metal, it will beep and the target icon will flash. The LCD display will
also show the reading value and the depth at which the target was detected.
Note that the depth is only a reference point.
CAUTION!
side parallel to the probe. Moving the coin sideways may cause false readings and
unstable readings.
OPERATING THE UNIT OUTDOORS
1. Press the POWER button to turn on the unit.
2. Set the desired operating mode (see "OPERATING THE UNIT INDOORS", section
2).
3. Adjust the sensitivity (see "OPERATING THE UNIT IN ROOMS", step 3).
CAUTION!
(SENS) to high. However, do not set the sensitivity level to maximum, or the detector
will pick up interference and false signals from the transmitting antenna and other
electrical lines. The detector will have unstable and erratic readings.
4. Find an outdoor location where there is no metal.
5. Place a sample of the material to be found by the detector (such as a gold ring
or coin) on the ground.
Do not test the detector on the floor inside a building. Most
The detector will detect a coin more easily if it is held with its flat
To detect a deeply buried target, you can set the sensitivity level

Publicidad

loading