Agility Removal; Troubleshooting - Permobil ROHO AGILITY Back Support Fixed Hardware Manual Del Operador

AGILITY Removal

Warning: DO NOT remove the AGILITY while the individual is seated in the wheelchair.
Option A: If the wheelchair canes have push handles or other
equipment that may interfere with installation:
1. Use the Allen wrench to loosen the bolt on both sides.
2. Unclip the pivoting band from the adjustment cylinder.
3. Open the pivoting band.
4. Remove the AGILITY from the wheelchair canes.
Note: Refer to "AGILITY Installation" for reference images.

Troubleshooting

For additional assistance, contact the equipment provider, distributor, or Customer Support.
Not able to correctly attach components during
"AGILITY Installation".
Not able to correctly attach or secure
components during "AGILITY Installation".
Not able to correctly attach components during
"AGILITY Installation" or "Height Adjustment".
Not able to correctly attach components during
"Seat Depth and Angle Adjustment".
A component is damaged.
ROHO AGILITY Fixed Hardware Operation Manual
Option B: If the wheelchair canes do not have push handles or
other equipment that may interfere with removal:
1. Use the Allen wrench to loosen but do not remove the bolt on
both sides.
2. Slide the pivoting bands off of the canes.
» Make sure the mounting hardware is flush against the wheelchair canes.
» Make sure that the Fixed Hardware is the same height on both sides. Use a tape measure or
ruler, if necessary.
» The normal installation location of the Fixed Hardware is on the back side of the canes. If
a rigidizer bar interferes with the Fixed Hardware when installed in the normal location, the
Fixed Hardware may be installed on the front side of the canes. In either orientation, the left
(L) and right (R) Fixed Hardware should be correctly located from the viewpoint of the installer.
» Make sure the mounting hardware is flush against the wheelchair canes.
» Make sure that the width is set appropriately for the wheelchair. The distance between
wheelchair canes may vary. If the Fixed Hardware will not correctly attach and secure to
the wheelchair canes, a width adjustment may be needed. Adjust the width as described
in "AGILITY Installation". It may take a few attempts to find the ideal width position for the
wheelchair.
» If you are not able to secure the Fixed Hardware on the wheelchair canes, you may need to
use Cane Sleeves. (See "Wheelchair Cane Compatibililty".)
» Make sure the Fixed Hardware -- left (L) and right (R) -- are on the correct sides.
» Make sure the width/height adjustment nuts are in the same position in the triangle brackets.
Use the reference grooves as guides, which are below the horizontal slots on the triangle
brackets. (See "AGILITY Installation".)
» Make sure that the Fixed Hardware is the same height on both sides. For each side, count the
number of squares openings that are visible in the sliding height adjustment bar (See "Height
Adjustment" or "Parts Detail".)
» Make sure that the left (L) and right (R) depths are equal. Compare the markers on the top of
the triangle brackets.
» Make sure that the left (L) and right (R) hardware are rotated to the same angle. Compare the
markers on the front of the hardware.
» Contact Customer Support for a replacement.
11