Product Specifications; Back Shell Hardware Installation; Wheelchair Compatibility - Permobil ROHO AGILITY Back Support Fixed Hardware Manual Del Operador

Product Specifications

Materials - Fixed Hardware: Zytel, glass-filled nylon, stainless
steel, aluminum and polypropylene
AGILITY Fixed Hardware Weight: 1.75 lb. (0.8 kg)
Accessories Compatible with AGILITY Fixed Hardware:
ROHO Privacy Shield (non-medical accessory)

Back Shell Hardware Installation

Note: Follow these instructions if the back shell hardware is not yet installed on the AGILITY.
1. Use the box end wrench to loosen and remove the width/height
adjustment nuts. Repeat for both sides.
Place the left (L) and right (R) Fixed hardware onto the left (L) and
right (R) width/height adjustment plates.
Right back shell hardware is shown.
2. Replace the width/height adjustment nuts.
Finger-tighten the width/height adjustment nuts.
Repeat for both sides.
3. Tighten the width/height adjustment nuts with the box end wrench until snug + one-quarter turn.
Repeat for both sides.
Note: If a torque wrench is available, tighten to no more than 42 ± 2 inch-pounds (4.75 ± .25 Newton-
meters). Repeat for both sides.

Wheelchair Compatibility

Warning: AGILITY hardware is compatible with many wheelchairs that recline, tilt, or are angularly adjustable up to and including a back
angle of 60 degrees. Beyond 60 degrees, AGILITY hardware may be damaged, the AGILITY may disconnect from the wheelchair, and you may
be vulnerable to falling and serious injury. Consult a with a clinician or equipment provider to determine if AGILITY hardware is compatible with the
wheelchair.
Wheelchair Cane Compatibility: Measure the diameter of the back canes.
Warning: AGILITY Fixed Hardware is NOT intended to be installed on back cane diameters < 1 in. (< 2.5 cm) without Cane Sleeves. Doing
so may result in an installation that is NOT secure. Consult with a clinician or equipment provider to determine if the back canes are compatible
with AGILITY Fixed Hardware.
Circular back cane diameters (A):
1 in. to < 1¼ in. (2.5 cm to < 3.0 cm)
¾ in. to < 1 in. (2.0 to < 2.5 cm)
ROHO AGILITY Fixed Hardware Operation Manual
Back Shell Hardware:
- Width/Height Adjustment Bolts: M6 x 1.0 x 25mm Carriage Bolt
- Depth/Angle Adjustment Bolt: M6 x 1.0 x 30mm Socket Head Cap Screw
- Bolt: M6 x 1.0 x 35mm Socket Head Cap Screw
Expected product lifetime: 5 years
Cane Sleeves are not required.
Cane Sleeves are required. See "Cane
Sleeve Installation".
4
R
A
A