Agility Installation; Installation Options - Permobil ROHO AGILITY Back Support Fixed Hardware Manual Del Operador

Wheelchair Compatibility, continued
Cane Sleeve Installation (If Needed)
Warning: Cane Sleeves are required for wheelchair back cane diameters of ¾ in. to less than 1 in. (2.0 to < 2.5 cm). See "Wheelchair Cane
Compatiblity" in "Product Specifications".
Note: If you need to use Cane Sleeves, perform the following instructions after the AGILITY has been placed onto the wheelchair canes, but before
tightening the bolts.
Spread open the Cane Sleeve
and place it on the wheelchair
cane. Slide the Cane Sleeve down
inside the pivoting band. Repeat
for both sides.

AGILITY Installation

STOP: If the back shell hardware is not yet installed on the AGILITY back shell, see "Back Shell Hardware Installation".
Warnings:
- DO NOT install or remove an AGILITY while the individual is seated
in the wheelchair.
- DO NOT adjust the width of an AGILITY while the individual is seated
in the wheelchair.
- After you install or adjust an AGILITY, and before the individual
transfers into the wheelchair, make sure that all hardware is securely
tightened. Refer to the recommended torque specifications.

Installation Options:

Follow the instructions for "Installation Option A" if the wheelchair
canes have push handles or other equipment that may interfere with
installation.
Otherwise, follow the instructions for "Installation Option B".
Loosen the Bolts - Option A and Option B
1. For both sides: Loosen the bolt.
Note: The end of the bolt should
be flush with the adjustment
cylinder.
ROHO AGILITY Fixed Hardware Operation Manual
For both sides, tighten the bolt
with the Allen wrench as directed
in "Installation Option A" or
"Installation Option B".
Note: It may be helpful to position
the opening of the Cane Sleeve
toward the back shell.
IMPORTANT!
» The cover should be installed on the back shell before installing an
AGILITY. Refer to the instructions provided with the ROHO AGILITY
Back Support.
» During installation and removal, provide support to the center of the
back shell to help keep the left (L) and right (R) hardware even and
flush up against the canes.
» Lock the wheelchair wheels before beginning installation.
» An AGILITY installation video is available at permobilus.com.
AGILITY Installation Steps for Option A or Option B:
1. Loosen the bolts.
2. Place the AGILITY on the wheelchair.
3. Tighten the bolts.
4. Complete attachment.
5. Height adjustment.
6. Seat depth and angle adjustment.
IMPORTANT! The bolt
should NOT disengage from the
adjustment cylinder.
5