Adjustment Of Tie-Rod/Head Unit - FAR KJ 45/S Traducción De Las Instrucciones Originales

TIE-ROD/HEAD UNIT ADJUSTMENT (fig. f14-f15-f16)
Changing the length of the insert to clamp, the position of
the head (B) compared to the threaded tie rod (A) should
be adjusted.
Disconnect the compressed air feeding from the tool.
Screw an insert of the desired length on the threaded tie
rod manually until the insert head touches the riveting tool
head (B). The head is adjusted correctly if the threaded tie
rod comes out of the insert screwed on it of about 2 mm.
Otherwise unblock the ring nut (C) with a 22 mm standard
spanner then screw or unscrew the head (B) up to the right
position, and block the ring nut (C).
ATTENTION!
Disconnect the machine before carrying out the
above-mentioned operations.
A
B
18
All manuals and user guides at all-guides.com
C
f14
Date 01-2011
GB
f15
C
22 mm
f16
KJ 45/S KJ 45/S
B
Revisione - 03