Publicidad
Idiomas disponibles
Idiomas disponibles
f
..................... wear eye protection
i
..................... Class II Construction
(double insulated)
g
..................... wear hearing
protection
a
..................... read all
documentation
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
ASSEMBLY AND ADJUSTMENTS
WARNING:
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start‑up
can cause injury.
Assembly Tools Required
•
Crosshead Screwdriver
Attaching Guard to Trimmer (Fig. A, B)
WARNING:
assembled to hedge trimmer. The use of the hedge
trimmer without the proper guard provided may result
in serious personal injury.
The trimmer is shipped with the guard attached to the
trimmer with a plastic zip tie.
Attaching Guard to Trimmer (Fig. A, B)
1. Remove guard retaining screw
screwdriver (not supplied).
2. Slide the guard
2
fully onto the front of the
trimmer housing.
3. Insert the guard retaining screw
the side of the housing and tighten securely.
Attaching Extension Cord to Trimmer
(Fig. A, C)
An extension cord retainer is built into the switch handle that
helps prevent the tool from coming unplugged.
1. Double the extension cord several inches from the end.
Feed the loop onto the cord retainer
Fig. C.
2. Gently tug on the cord to insure that it is firmly retained
in the trimmer's handle.
OPERATION
WARNING:
n
..................... avoid staring at
light
l
or AC............ alternating current
Ah ....................... amp hours
CSPM .................. cut strokes per
minute
To reduce the risk of
Only use with guard properly
10
with the crosshead
10
into the opening on
7
as shown in
To reduce the risk of
serious personal injury, turn unit off and
disconnect it from power source before making
any adjustments or removing/installing
attachments or accessories. An accidental start‑up
can cause injury.
Proper Hand Position (Fig. D)
WARNING:
personal injury, ALWAYS use proper hand position
as shown.
WARNING:
personal injury, ALWAYS hold securely in anticipation of
a sudden reaction.
Proper hand position requires one hand on the switch
handle
6
and one hand on the T handle
unit by the blade guard
2
.
Trigger Switch (Fig. A)
WARNING:
in the ON position.
CAUTION:
stems greater than 5/8" (16 mm). Use the trimmer
only for cutting normal shrubbery around houses
and buildings.
To turn the tool "ON", shift the lock off button
the trigger switch
5
. Once the unit is running, you may
release the lock off button.
To turn the tool "OFF", release the trigger.
Trimming Instructions (Fig. E–I)
DANGER:
Keep hands away from blade .
WARNING:
observe the following:
•
Read instruction manual before using. Save
instruction manual.
•
Check the hedge for foreign objects such as wires or
fences before each use.
•
Keep hands on handles. Don't overreach.
•
Do not use under wet conditions.
:
CAUTION
Blade may coast after turn off.
Extension Cord (Fig. E)
Always keep extension cord behind trimmer and away
from the trimming operation. Never drape it over a hedge
being trimmed. If you cut or damage the cord, unplug it
English
To reduce the risk of serious
To reduce the risk of serious
3
. Never hold the
Never attempt to lock a switch
Do not use blade to cut
4
and squeeze
To guard against injury,
7
Publicidad
