AUTOFEED SHREDDING OPERATION
AUTOFEED SHREDDING CAPACITY:
Shreds:
•
Maximum 120 sheets of A4.
•
Up to 10 sheets stapled paper stacks.
•
Up to 10 sheets clipped paper stacks.
POWER ON SHREDDER
1. Plug into ground standard household power outlet (220-V).
2. Put main power switch in ON (-) position.
3. Turn power on.
OPEN LID AND LOAD PAPER
•
Paper should be flat and aligned with paper tray.
CLOSE LID
•
The shredder automatically starts when you close the lid.
MANUAL FEED SHREDDING OPERATION
POWER ON SHREDDER
1. Plug into ground standard household power outlet (220-V).
2. Put main power switch in ON (-) position.
3. Turn power on.
4. Make sure you do not exceed sheet count per pass (10 sheets
max.). Insert paper as straight as possible into feed slot and re-
lease.
5. Insert one credit card at a time into the middle of the feed slot.
NOTE
•
Always turn off and unplug the shredder when not in use.
•
This shredder will shred staples and small paperclips. It is rec-
ommended that you remove paperclips whenever possible to
extend the lifespan of your shredder.
•
Only shred credit cards by feeding them vertically into the mid-
dle of the entry, releasing when shredding begins. Never feed
more than one credit card at a time.
•
Overfeeding the shredder: shredding beyond the specified
sheet capacity can result in extensive damage to the shredder.
Overfeeding will strain the machine and quickly wear and break
the cutting blades and internal components.
•
Overheating with extended use: in the event that the shredder
has shred continuously beyond the maximum running time
and overheating, the unit will automatically shut off. If this hap-
pens, switch the shredder off for 45 minutes or longer before
resuming normal operation.
3
AUTOFEED TRAY
SHEET CAPACITY
120 sheets of A4
PAPER SHRED
SIZE
PAPER TRAY SIZE
PAPER ENTRY
WIDTH
CREDIT CARD
CAPACITY
60 min. on / 45
DUTY CYCLE
VOLTAGE
Figure 1
Figure 2
–
O
ON
OFF
t
MANUAL FEED
SLOT
10 sheets of A4
4.0 mm x 12.0 mm
A4
N/a
220 mm
n/a
One per pass
20 min. on / 45
min. off
min. off
220 V~50 hz / 1.5 A
push
down
CORRECT FIT
CORRECT FIT
W W W . Q - C O N N E C T . C O M
push
down