Connecting A Mobile Device; Settings; Temperature Cut-Out - Festool CTC SYS I Manual De Instrucciones

Remote controls that have not been connected
previously can be connected directly.
A connection that has been created be­
tween remote controls and the cordless
mobile dust extractor will persist even af­
ter pressing the on/off button or removing
a battery pack (from the cordless mobile
dust extractor).
The cordless mobile dust extractor can be
connected to as many as five remote con­
trols at the same time. The cordless mo­
bile dust extractor can only be connected
to one battery-powered power tool at a
time.
If a cordless mobile dust extractor which
was initially switched on using the battery
pack is switched off using the remote con­
trol, the temporary connection between
the connected battery pack and the cord­
less mobile dust extractor will be lost. The
battery pack can then be connected again.
► Hold down the connection button [1-9] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-10] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Press the MAN button [1-18] on the remote
control.
The remote control is permanently stored in the
cordless mobile dust extractor.
Resetting on the remote control
Resetting deletes the connection between a re­
mote control and the cordless mobile dust ex­
tractor.
► Hold down the connection button [1-16] and
the MAN button [1-18] for 10 seconds.
The LED indicator [1-17] lights up purple, if the
reset has taken place.

10.3 Connecting a mobile device

The cordless mobile dust extractor can be con­
nected to a mobile device (e.g. for a software
update) using the Festool Work app.
► Hold down the connection button [1-9] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-10] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Follow the instructions provided in the
Festool Work app to authorise the secure
connection.

11 Settings

11.1 Adjusting the suction power
► Press the plus or minus button for the suc­
tion power adjustment [1-11] while extract­
ing.
The green LEDs on the status display [1-12] in­
dicate the current performance level.
11.2 Connecting sleeve
The bypass function of the connecting
sleeve [1-3] prevents strong suction from
sanding machines and floor nozzles on smooth
surfaces.
Open
► Turn the adjusting ring to the "OPEN" posi­
tion.
Close
► Turn the adjusting ring to the "CLOSE" posi­
tion.

11.3 Temperature cut-out

To protect against overheating, the tempera­
ture cut-out switches off the cordless mobile
dust extractor before it reaches the critical
temperature. The status display LED [1-12] in­
dicates a fault.
LED lights up red
► Switch off the cordless mobile dust extrac­
tor, let it cool down.
► Switch the cordless mobile dust extractor
on again after approx. ten minutes.
11.4 Connecting with the T-Loc
The cordless mobile dust extractor can be
closed, opened and connected by turning the T-
Loc:
– Close the cordless mobile dust extrac­
tor [3a].
– Open the cordless mobile dust extrac­
tor [3b].
– Connect the cordless mobile dust extractor
to the storage box [3c].
Before lifting, always close the T-Loc at
the cordless mobile dust extractor or
connect to the storage box and check for secure
holding.
Max. load for connection to other Systainers:
44.09 lbs. (20 kg)
English
Excessive temperature
13