Tool Change - Mafell FM1000 Instrucciones De Funcionamiento Y Seguridad

FM1000

4.4 Tool change

The milling spindle is equipped with a precision collet chuck to hold the tools. The locking button controls the
spindle lock, which makes it easier to tighten and loosen the union nut.
Use the following procedure to change the tool:
1. Pull out the power plug of the machine.
2. Put down the cable where you can see it.
3. Press and hold the locking button (1) to lock
the milling spindle.
4. Loosen the union nut with the 17-mm single
open-end wrench [0.67 in] or the ER 16 M
chuck key.
5. Pull off the old tool from the front.
6. Insert the new too into the tool holding fixture
until it hits the stop.
7. Press and hold the locking button (1) to lock
the milling spindle.
8. Tighten the union nut with the 17-mm single
open-end wrench [0.67 in] or the ER 16 M
chuck key.
9. Check to ensure that the tool is seated
properly.
Tool changed.
✓
01/2022
Caution
Risk of burns/cutting
The inserted tool can heat up considerably during longer work processes.
Furthermore, the cutting edges of the insert tool are sharp.
➢ Wear protective gloves when changing tools.
Fig. 5: Removing the tool
Fig. 6: Inserting the tool
15