Service And Maintenance; Storage - Mafell FM1000 Instrucciones De Funcionamiento Y Seguridad

5.4.1 Visual output of the remaining running time
The visual output signals on the setting wheel (3) show the operating status. The lamp at the setting wheel
shines permanently blue as long as there is no overload on the milling motor.
If the milling motor is overloaded, the calculated remaining time is displayed as a red blinking code. The table
below shows the relationship between the blinking code and the related remaining runtime.
Operating mode
Continuous operation
Overload operation
(motor running)
Shutdown
Table 5: Relationship between remaining running time and the related visual output signal at the setting wheel
If the remaining run time is not sufficient for your application, reduce the load or the feed rate to be able to
switch back to continuous operation.
6

Service and maintenance

MAFELL machines are of a low-maintenance design.
Have the carbon brushes replaced after a maximum of 125 to 150 operating hours.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.

6.1 Storage

Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
18
Remaining runtime in
seconds
Unlimited
< 160
< 80
< 40
< 20
< 10
< 5
0
Setting wheel - light
Blue, permanent
1 x red pulse
2 x red pulse
3 x red pulse
Red, permanent
FM1000
01/2022