Front Panel - FONESTAR ZS-2000M Manual De Instrucciones

ZS-2000M

FRONT PANEL

1.- PTT microphone clip: the PTT microphone clip is used for hanging the PTT microphone (Optiona).
2.- Manually emergency mode button: a protective cover covering the manual emergency mode button
prevents pushing the button by mistake.
When switching to the emergency mode is necessary, raise the protective cover and then press the
button. The button indicator light turns red.
3.- PTT microphone socket and indicator light: the PTT microphone socket is used to connect the PTT
microphone (Optional) to the ZS-2000M.
The indicator light is off when on standby. When the PTT microphone is being used, the light turns
green. When the microphone experiences a fault, the light turns orange..
4.- Device state indicator lights: figure 3 shows the schematic diagram of the ZS-2000M device state
indicator lights. Refer to Table 2 for relevant descriptions.
5.- Function buttons: figure 4 is the schematic diagram of the ZS-2000M function buttons. Refer to Table
3 for relevant descriptions..
6.- Zone selection buttons and state indicator lights: figure 5 is the schematic diagram of the
ZS-2000M zone selection buttons and state indicator lights. Refer to Table 4 for relevant descriptions.
7.- Sound source selection buttons and state indicator lights: figure 6 is the schematic diagram of the
ZS-2000M sound source selection buttons and state indicator lights. Refer to Table 5 for relevant
descriptions.
Figure 3 Schematic Diagram of the ZS-2000M Special State Indicator Lights
- POWER: indicates the power supply status. This light is lit green when working normally and orange if
the main or standby power supply fails.
- GENERAL FAULT: general fault state indicator light. When the equipment detects any fault, this indicator
Figure 2 Schematic Diagram of the ZS-2000M Front Panel
- 9 -
EN