Eco Mode; Other Modes; Cleaning And Maintenance - Domo DO7349H Manual De Instrucciones

ECO MODE

The unit uses the Eco mode to measure the ambient temperature and determine the power setting itself
in order to operate in the most energy-efficient way. Press the Eco mode button to activate this mode.
The indicator lamp on the display will light up
· If the ambient temperature is lower than or equal to 18°C, the unit will operate on high.
on the display.
· If the ambient temperature is higher than 18°C and lower than 25°C, the unit will operate on low.
will appear on the display.
· If the ambient temperature is equal to or greater than 25°C, all modes will be disabled.

OTHER MODES

Overheat protection
This heater is protected with an overheat protection that switches off the heater automatically in case of
overheat, e.g. due to the total or partial obstruction of the grids. The overheating shut-off switches off the
temperature inside when the appliance exceeds the normal running temperature. The heating element
will automatically stop working. In this case, unplug the appliance. If this happens, switch off the unit and
wait until it has cooled down sufficiently (±10 minutes). Make sure that the air outlet is not covered. Then
switch it back on as described above. The appliance should operate normally. Should the problem persist,
please contact the nearest customer service.
Tip-over safety
The appliance will turn off when it tips over. When you set the unit upright again, it will go back into
standby mode.
Automatic switch-off
If no timer is set, the unit will automatically switch off after 12 hours of operation. This is to prevent an
accident if you forget to turn it off. The 12 hours start counting from the last key touch.
Memory mode
If you switch the unit off with the on-off button, but do not turn off the switch or unplug the cord, the
unit will remember the last settings (except timer settings). If you turn off the switch or unplug the power
cord, the default settings will be used when it is switched back on (35°C and low power setting).

CLEANING AND MAINTENANCE

· Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down
completely.
· To avoid the risk of electric shock, do not clean the heater with water and do not immerse it. Clean the
housing with a damp cloth.
· Do not use petrol, thinners, corrosive cleaning agents, solvents, or
chemicals.
· We recommend cleaning the filters once a month to keep the unit
running at its best.
Dust particles in the appliance may cause over-heating.
· Remove dust from the air outlet with a vacuum.
· Remove the air intake vent and filter.
www.domo-elektro.be
.
will appear
39
DO7349H