Machine Information; Technical Specifications - VONROC CS504DC Traducción Del Manual Original

EN
t) The telescopic chain saw should be stored in a
dry, high or locked up place out of the reach of
children.
u) Replace worn or damaged parts for safety.
v) Do not attempt to repair the machine unless
you are qualified to do so.
w) Hold the product securely with both hands.
SAFETY WARNINGS FOR BATTERY
a) Do not open the battery. Danger of short-
circuiting.
b) Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
c) In case of damage and improper use of the bat-
tery, vapours may be emitted. Ventilate the area
and seek medical help in case of complaints.
The vapours can irritate the respiratory system.
d) Use the battery only in conjunction with your
Vonroc product. This measure alone protects
the battery against dangerous overload.
e) The battery can be damaged by pointed objects
such as nails or screwdrivers or by force
applied externally. An internal short circuit can
occur and the battery can burn, smoke, explode
or overheat.
SAFETY WARNINGS FOR CHARGER
Intended use
Charge only CD801AA and CD803AA type recharge-
able Battery packs with the charger. Other types
of batteries may burst causing personal injury and
damage.
a) The appliance is not to be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction.
b) Children being supervised not to play with the
appliance.
c) Do not recharging non-rechargeable batteries!
d) During charging, batteries must be placed in
the well ventilated area!
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
10
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The machine is intended for domestic use, for
pruning trees and shrubs at elevated height, while
the user is situated on the ground. The machine is
not intended to be used on a ladder or steps. The
machine is not designed to cut inorganic material.
This tool is not intended for commercial or indus-
trial use.

TECHNICAL SPECIFICATIONS

This manual has been drawn up for
different sets / article numbers. Check the
corresponding article number in below
specifications table for the correct
composition and contents of your set.
Batteries
Model No.
included
CS504DC
-
S_CS504DC
CD801AA
S2_CS504DC
2 x CD801AA
S3_CS504DC
CD803AA
Machine information
Voltage
Chain speed
Chain bar length
Chain length
Chain pitch
Chain gauge
Length adjustment
Sound pressure level (LpA)
Sound pressure level (LWA)
Guaranteed LWA
Vibration
Weight
Chargers
included
-
CD802AA
CD802AA
CD802AA
20V
5m/s
200mm
44T
1/4"
0.043"
200-260cm
78.2dB, k=3dB
88 dB(A), K=3dB(A)
91dB
front handle a =2.74m/s
2
h
rear handle a =2.69m/s
2
h
K=1.5m/s
2
2.3kg
WWW.VONROC.COM