Troubleshooting - Husqvarna K1 PACE Manual Del Usuario

3. Turn the front pulley clockwise with the combination
wrench. At the same time, push the drive belt onto
the pulley.
4. Attach the belt guard. Refer to
PACE on page 3 .
To do a check of the water supply system
1. Examine the nozzles on the blade guard and make
sure that they are not clogged.
Troubleshooting of the product
Note:
For troubleshooting of the battery and the
battery charger refer to related operator's manual.
Symbol on the control pan-
el
30
Product overview K1

Troubleshooting

Problem
The product does not start.
No LEDs come on when
you push the On/Off but-
ton.
No reaction from the motor
when you push the power
trigger.
The motor makes a sud-
den movement when you
push the power trigger,
then stops.
The product stops during a
kickback.
2. Clean as necessary.
3. Examine the filter on the water connector. Make sure
that it is not clogged.
4. Clean as necessary.
5. Examine the hoses and make sure that they are not
damaged.
Cause
Defective battery.
Defective plug between
battery and product.
The battery is not correctly
installed in the product.
Servicing is necessary.
Servicing is necessary.
Servicing is necessary.
The X-Halt function is en-
gaged.
Solution
Push the On/Off button to
do a check of the battery.
A minimum of 1 green LED
must come on.
Make sure that the pow-
er connectors between the
battery and the product are
not dirty or damaged.
Remove the battery and in-
stall it correctly.
Speak to an approved
Husqvarna service center.
Speak to an approved
Husqvarna service center.
Speak to an approved
Husqvarna service center.
Wait for the X-Halt to dis-
engage.
1598 - 002 - 14.02.2022