Know Your Generator - Craftsman 580.327130 Manual Del Operador

KNOW YOUR GENERATOR

Read the owner's manual and safety rules before operating your generator.
Compare the illustrations with your Generator to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
Fuel Shut Off
120/240 Volt AC,
20 Amp Receptacle
120 Volt AC, 20 Amp
Receptacles
120 Volt AC, 20 AC Amp Receptacles — May be
used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical
lighting, appliance, tool and motor loads.
120/240 Volt AC, 20 Amp Receptacle
used to supply electrical power for the operation of
120 and/or 240 Volt AC, 20 Amp, single phase, 60 Hz
electrical lighting, appliance, tool and motor loads.
Air Cleaner — Filters air as it is drawn into the engine
carburetor.
Choke Lever — Used when starting a cold engine.
Circuit Breakers — Each receptacle is provided with
a "push to reset" circuit breaker to protect the
generator and any connected tools or appliances
against electrical overload.
Fuel Tank
Grounding Wing Nut
—
May be
Circuit Breakers
Fuel Shut Off — Make sure fuel shut off is open
before starting engine. Close when engine is shut off
Fuel Tank — Tank holds 4 U.S. gallons of unleaded
gasoline.
Grounding Wing Nut — Provides a convenient tie
point for connecting generator to earth ground.
Oil Filter — Filters engine oil for longer engine life.
Run/Stop Switch — Set this switch to "Run" before to
set in starting mode. Set the switch to "Stop" to shut
off a running engine. Located on the engine block.
Spark Arrestor Muffler — Exhaust muffler lowers
engine noise and is equipped with a spark arrestor
screen.
5
Air Cleaner
Run/Stop Switch
Choke Lever
Oil Filter
Spark Arrestor Muffler