Therabody RecoveryAir PRO Manual De Instrucciones página 6

EN RecoverAir PRO Programs
Interval preset program
The Interval program allows for a cycle to turn on and then off in a sequential selected amount
of time.
• A directional massage is applied with a sequential cycle, and alternates between intervals
of being under treatment (Time On) and no treatment (Time Off).
• Start by selecting the Time On (in minutes), the Time Off (in minutes), and the total Interval
program time (in hours).
• The treatment begins with the selected Time On, and after this treatment is completed, the
pump pauses for the selected amount of Time Off, and then back to the selected Time On.
• This Time On/Time Off interval continues automatically until the total treatment time is
completed (up to 8 hours).
PRO Mode (Custom)
The PRO Mode allows you to create a fully customized program that's unique to you.
• You can use the Pretreatment program or you can choose from four inflation cycles:
Sequential, Isolation, Wave, or Flow.
• During your treatment, you can change the treatment parameters, but you can't change
the selected inflation cycle and can't turn the pre-selected program ON/OFF.
Pretreatment (See Figure 3)
• Pretreatment treats the proximal areas first.
• A specific pattern is applied, and the duration varies according to garment size (5–12
minutes) with a preselected pressure of 30 mmHg in all chambers that cannot be changed.
• Sequence 1 is carried out six times.
• Sequence 2 and Sequence 3 are carried out only once.
Sequential inflation cycle (see page 4)
Isolation inflation cycle (see page 4)
Wave inflation cycle
• The Wave inflation cycle starts at the base of the limb, over the foot.
• As one chamber inflates, the previous chamber starts deflating, so at any one time a small
area is being compressed.
• For example: When chamber 2 is full, then chamber 1 starts to deflate, while chamber 3
starts to inflate, so for a moment, there are 2 chambers reaching the target pressure at the
same time. (See Figure 4)
5
Time On Time O
10 — 90 min 10 — 90 min
(5min per step) (5min per step)
Time On Time Off
No Treatment
Figure 1 - Sequential Cycle Mode
Sequential CycleTreatment
Total Time
Sequence 1 Sequence 2
Figure 3 - Pretreatment Sequences
Figure 4 - Wave Cycle Mode
Total (hrs)
1 — 8 hours
(1hr per step)
Time On
Sequential Cycle . . .
Treatment
Sequence 3
Chamber 4
Chamber 3
Chamber 2
Chamber 1