Enable The Device; Opening The Drawer; Inserting The Driver 2 Chart; Inserting The Driver 1 Chart - VDO MTCO 1324 Instrucciones De Servicio

Enable the device

Opening the drawer

The drawer may only be opened, if ...
• the vehicle is at a standstill and
• the ignition is switched on.
1. Press the
key.
In the display, the "Ejection active"
symbol is shown. Additionally, a
process indicator shows that this
process may take some time.
Wait until the drawer has been
unlocked.
2. a) Pull out the blocked drawer to the
limit stop.
Do not try to tip down this drawer
design!
b) Pull out the hinged drawer to the limit
stop and tip it down.
Remove driver 1 chart if necessary.
3. Tilt separating plate entirely upwards.
Remove driver 2 chart if necessary.
© Continental Automotive GmbH
(Page 3, figure II)

Inserting the driver 2 chart

Before starting to drive, the centre
field of the chart has to be duly
recorded, see page 37.
4. The driver 2 inserts the recorded chart
with the front side facing up in the
"pear-shaped" chart carrier.
Make sure that the chart is located
below the spring element (c).
5. Tilt separating plate downwards.

Inserting the driver 1 chart

6. The driver 1 inserts the recorded chart
with the front side facing up to the sepa-
rating plate in the chart carrier.
Make sure that the tachograph chart
is located under the holding-down
device (d) and the latches (e) of the
pear-shaped chart carrier.
Comment on 1 driver operation
In the 1 driver operation, only the chart for
driver 1 is to be inserted on the separating
plate.
7. Make sure that the position of the chart
carrier is temporally correct. The time
scale of the chart has to be adjusted to
the current time of the display at the
respective marker (f).
If this is not the case please start the
chart carrier settings update,
see page 34.
27