Descargar Imprimir esta página

Odor Removal; Light Replacement; Charcoal Filter - Danby DOM014401G1 Manual Del Propietário

Ocultar thumbs Ver también para DOM014401G1:

Publicidad

Idiomas disponibles

Idiomas disponibles

CARE AND MAINTENANCE
GREASE FILTERS
The grease fi lters should be cleaned at least once
a month. Never operate the fan or the microwave
without the fi lters installed.
Gently pull down on the tab at the top of the fi lter
to remove it. Soak the fi lter in a sink or dish pan
fi lled with hot water and detergent. DO NOT use
ammonia or other alkali cleaners; they will react
with the fi lter material and darken it. Agitate and
scrub with a brush to remove accumulated dirt.
Rinse thoroughly and shake dry.
Replace the fi lters and ensure they click into place.

CHARCOAL FILTER

The charcoal fi lter is used in a non-ventilated
(recirculating) installation. The charcoal fi lter should
be changed every 6 - 12 months depending on use.
Ensure the microwave is unplugged before
removing the fi lter. Use a screwdriver to remove two
screws from the top panel. Open the door and lift
the louver up. Change the charcoal fi lter, push the
louver back into place and replace the screws.
To purchase replacement fi lters either contact
the consumer service department or visit
www.DanbyApplianceParts.com or www.
DanbyApplianceParts.ca.

ODOR REMOVAL

To remove odors from the microwave:
1. Combine a cup of water with the juice and skin
of one lemon in a microwavable bowl.
2. Microwave on full power for 5 minutes.
3. Wipe the inside of the appliance and glass tray
and roller ring thoroughly with a warm, damp
cloth.
DISPOSAL
This product should not be treated as ordinary
household waste, it should be transported to the
appropriate collection point for the recycling of
electrical components. For information on local
waste collection points, contact your local waste
disposal agency or government offi ce.

LIGHT REPLACEMENT

1. Unplug the microwave.
2. Remove the screw from the glass window frame.
3. Remove the light bulb and replace with a bulb
no larger than 30 watts.
4. Close the glass window frame and replace the
screw.
Caution: The light cover may be very hot. Do not
touch the lamp cover while the light is on.
11

Publicidad

loading