Working With Special Accessories; Working With The Roller Edge Guide - Mafell K65 18M bl Instrucciones De Funcionamiento Y Seguridad

K65 18M bl/KSS60 18M bl

5.10 Working with special accessories

Various special accessories are available for the machine. An overview can be found in chapter 8 Optional
accessories.
Some utilization methods are explained below.

5.10.1 Working with the roller edge guide

The roller edge guide (I) is used for sawing in parallel to an existing edge. The guide fence can be mounted on
the right (motor side) or the left (tool side) side of the machine. The possible adjustable distance is 30 to 210
mm [1.18 - 8.27 in] on the right side and 12 mm to 40 mm [0.47 - 1.57 in] on the left side.
The selected width is shown at the scales on the guide bars. The edges with the red markings on the base
plates are used as pointers.
Use the following procedure to install the roller
edge guide:
1. Loosen the wing screws (5) on both sides.
2. Insert the roller edge guide I into the guide
provided for this purpose.
➢ It can be mounted on the left or right side
of the machine.
3. Tighten the wing screws (5) on both sides.
The roller edge guide is installed.
✓
01/2022
Warning
Risk of injury from defective guard
There is a risk that the roller edge guide interferes with the operation of the
lower guard if it is used below the minimum dimensions. It is possible that
the saw blade is then freely accessible.
Use the roller edge guide only in the permissible cutting ranges. To
➢
ensure this, take note of the scales on the guide bars.
Fig. 25: Installing the roller edge guide
27