revised 03/2018
Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
Squeegee installation
1.
Install the squeegee (30) and fasten it with the handwheels (34), then connect the vacuum hose (31) to the squeegee.
2.
With the handwheel (35), adjust the squeegee so that the rear blades (18) - in all its length - touches the floor and the front
blade is slightly detached from the floor.
Washing water tank filling
1.
Open the plug (23).
2.
Fill the tank (22) with clean water by using the removable filler hose.
Do not fill the tank (22) completely, leave a few inches from the edge of the plug (23).
The water temperature must not exceed 40 °C.
Detergent EcoFlex tank filling
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
WARNING!
When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle floor cleaning detergents, wear suitable gloves and protections.
1.
Open the cover (20) and check that the recovery tank (19) is empty, otherwise empty it with the drain hose (23).
2.
Close the cover (20).
3.
Carefully lift the tank assembly (44).
4.
Open the detergent tank plug (42).
5.
Fill the tank with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not fill the detergent tank completely, leave a few inches from the edge.
NOTE
If the detergent tank is empty (in case of new system, system emptied for cleaning, etc.), in order to fill the hose quickly,
it may be useful to drain EcoFlex system once or several times (see the procedure in Maintenance chapter).
Operator's position adjustment
1.
Adjust the height of the heel support (5) to reach a comfortable position.
10/2010
MIDLITE GRIT 180
MIDGRIT 240
INSTRUCTIONS FOR USE
PROLENE
9098827000 - SC3000 26 D
ENGLISH
PROLITE
UNION MIX
15