Publicidad
Idiomas disponibles
Idiomas disponibles
revised 03/2018
FUSE CHECK/REPLACEMENT
NOTE
All machine electrical circuits are protected by auto-resettable electronic devices. The safety fuses activates only in case
of serious damage.
It is recommended to have the fuses replaced by qualified personnel only.
Refer to the Service Manual available at any Advance Retailer.
SAFETY FUNCTIONS
The machine is equipped with the following safety functions.
EMERGENCY PUSH-BUTTON
It is located in an easily accessible position (8). Press it firmly in case of immediate necessity to stop all machine functions.
To reset the machine operation, lift the tank assembly (44) and reconnect the battery connector (9).
ANTI-SKID SAFETY SYSTEM
This system reduces the speed when turning and when the machine tilts laterally to avoid sudden skids, this increasing the machine
stability in any condition.
DRIVER'S SEAT MICROSWITCH
It is located inside the driver's seat and it does not allow the machine drive system to operate if the operator is not seated on the
driver's seat.
ELECTROMAGNETIC BRAKE
It is built-in the front wheel and keeps the machine braked when the machine is off or stopped.
TROUBLESHOOTING
TROUBLE
The motors do not work; no warning LED turns on. The battery connector is disconnected.
The machine does not move and the display (71)
shows the error code:
At the machine start-up, the LED (68) of the One-
Touch push-button (67) flashes and the brushes
do not work.
The brushes do not work; the red warning LED
flashes.
The 3 warning LEDs (62) flash simultaneously.
The display (71) shows an error code as:
where "00" is replaced by a code different from
"t4".
10/2010
INSTRUCTIONS FOR USE
POSSIBLE CAUSE
The batteries are discharged.
The machine has been turned on by using the
ignition key and by keeping the pedal pressed.
The machine has been turned off without
lifting the brushes deck.
The batteries are discharged.
The brush motors are overloaded.
There are foreign materials (tangled threads,
etc.) preventing the brushes from rotating.
The machine electronic control system is in
alarm condition.
9098827000 - SC3000 26 D
REMEDY
Connect.
Charge the batteries.
Release the drive pedal.
If the problem persists, contact an authorised
Service Center.
Wait for the deck to lift before turning on again
the brushes by pressing the push-button.
Charge the batteries.
Use less aggressive brushes and/or avoid
working with extra pressure turned on.
Clean the brush hubs.
Turn off the machine and then turn it on again.
If the problem persists, contact an authorised
Service Center.
ENGLISH
27
Publicidad
