Tools Needed - Uline H-4888 Instrucciones De Montaje

TOOLS NEEDED

Power Drill
PAGE 3 OF 9
ANCHORING (OPTIONAL)
1/2" Diameter Masonry
Drill Bit
Nut
Lock Washer
Washer
Anchor Sleeve
Anchor Bolt
Base
Figure 10
9/16" Wrench
WARNING! Always wear safety glasses
to avoid personal injury.
1. Verify that the vertical bar rack is positioned in the
desired location. Mark the floor where all the holes
will be drilled, then move the rack in order to drill the
holes.
2. Using a 1/2" diameter masonry drill bit, drill a hole
in all marked locations approximately 2⁄" deep
into the floor.
NOTE: For the anchor to function properly, the
hole must not be larger in diameter than the
anchor bolt hardware.
Clean out debris and dust from inside the holes. Then align the rack
Fully insert the anchor bolt and anchor sleeve through the vertical
bar rack base and into the hole. Slightly tap down the anchor bolt
Slide the washer and lock washer over the anchor bolt. Then tighten
the nut with 9/16" wrench until the anchor bolt is secure. (See Figure
1-800-295-5510
uline.com
Hammer Safety Glasses
with a hammer if needed. (See Figure 10)
Repeat steps 4 and 5 for the remaining holes.
over all holes.
10)
0321 IH-4888