Publicidad
Idiomas disponibles
Idiomas disponibles
Federal Communications Commission (FCC) Interference
Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules�
These limits are designed to provide reasonable protection
against harmful interference in a residential installation� This
equipment generate, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications�
However, there is no guarantee that interference will not
occur in a particular installation� If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
of the following measures:
Reorient or relocate the receiving antenna�
Increase the separation between the equipment and receiver�
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected�
Consult the dealer or an experienced radio/TV technician for
help�
This device complies with Part 15 of the FCC Rules�
Operation is subject to the following two conditions:
EN
8
Direct current
Alternating current
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation�
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void
the user's authority to operate this equipment�
RF exposure warning
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment�
This equipment must be installed and operated in accordance
with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be collocated
or operating in conjunction with any other antenna or
transmitter�
To disable Wi-Fi module on the robot, power the robot ON�
Place the robot on the Self-empty Station making sure the
Charging Contacts on the robot and the Self-empty Station
Pins make a connection�
Press and hold the AUTO Mode Button on the robot for 20
seconds until the robot emits 3 beeps�
To enable Wi-Fi module on the robot, power the robot OFF
and then power ON� The Wi- Fi module is turned on when
the robot is restarted�
Publicidad
