Handle Assembly - Uline H-9823 Manual De Instrucciones

5. Push one plastic
end cap onto each
side of the track.
(See Figure 12)
6. Attach the front end
connectors using
front end connector
screws (A) and lock
washers (D).
(See Figure 13)
NOTE: Ensure holes on connector align with
holes on the track.
TRACK INSTALLATION
1. Install a plastic shelf support to top of each 72" post
on stationary units.
Handlebar x 2
(x 2 for H-9823, H-9824)
(x 3 for H-9825, H-9826)
1. Remove black caps from the top of the mobile
shelving unit posts.
NOTE: Only remove caps from one side of unit.
2. Use a rubber mallet to install one handle spring into
top of each post. (See Figure 16)
NOTE: It is recommended to hit the mallet on
the black plastic insert piece and not directly
on the top of the metal spring.
PAGE 4 OF 15
TRACK ASSEMBLY CONTINUED
Figure 12
A
D
Figure 13
HANDLE PARTS
Handle x 2
(x 2 for H-9823, H-9824)
(x 3 for H-9825, H-9826)

HANDLE ASSEMBLY

2. Slide the back end
connectors over the
shelf supports. Use a
rubber mallet to ensure
the connectors are
fully seated.
(See Figures 14-15)
NOTE: Repeat this
step for the front
track.
Spring
(x 4 for H-9823, H-9824)
(x 6 for H-9825, H-9826)
Figure 16
Handle Screw
(x 4 for H-9823, H-9824)
(x 6 for H-9825, H-9826)
Figure 14
Figure 15
Lock Washer
(x 4 for H-9823, H-9824)
(x 6 for H-9825, H-9826)
0222 IH-9823