Troubleshooting
EN
When the jug is on
the base and the
control panel does
not light up.
Ingredients
are difficult
to blend
Motor stops
suddenly during
operation
While using
Auto, Smoothie or
Vacuum function,
the light of any
of these three
buttons and/or
the Start/Stop
button keep
flashing, together
with a beep.
8
1. Not plugged into electricity. Replug cord into
power outlet.
2. Electricity not turned on. Check switch is turned
to ON position.
3. Master On/Off switch not in ON position.
Locate it on motor base and switch to ON
position.
Too many solid ingredients. Add more liquid
1.
Too much food may cause motor to cut out.
Turn off. Remove some of the food and power
up again.
2.
Long durations of operating or adding too
much hard food may trigger the protection
mechanism, causing the motor to stop. Rest
the blender for 20 – 45 minutes and restart it.
Try any/all of the following steps:
1. Press 'Start/Stop' button
2. Open the sound reducing cover, make sure jug
is in firmly in place and close the cover.
3. Rotate the dial back to the OFF position.
4. Press Vacuum button.
Please contact the service centre if fault
continues.